Step 8: Create Amazon DMS Source and Target Endpoints - Database Migration Guide
Services or capabilities described in Amazon Web Services documentation might vary by Region. To see the differences applicable to the China Regions, see Getting Started with Amazon Web Services in China (PDF).

Step 8: Create Amazon DMS Source and Target Endpoints

While your replication instance is being created, you can specify the source and target database endpoints using the Amazon Web Services Management Console. However, you can only test connectivity after the replication instance has been created, because the replication instance is used in the connection.

  1. Specify your connection information for the source Oracle database and the target Amazon Redshift database. The following table describes the source settings.

    Parameter Action

    Endpoint Identifier

    Enter Orasource (the Amazon RDS for Oracle endpoint).

    Source Engine

    Choose oracle.

    Server name

    Provide the Oracle DB instance name. This name is the Server name value that you used for Amazon SCT, such as "abc123567.abc87654321.us-west-2.rds.amazonaws.com".

    Port

    Enter 1521.

    SSL mode

    Choose None.

    Username

    Enter oraadmin.

    Password

    Enter oraadmin123.

    SID

    Enter ORCL.

    The following table describes the target settings.

    Parameter Action

    Endpoint Identifier

    Enter Redshifttarget (the Amazon Redshift endpoint).

    Target Engine

    Choose redshift.

    Servername

    Provide the Amazon Redshift DB instance name. This name is the Server name value that you used for Amazon SCT, such as "oracletoredshiftdwusingdms-redshiftcluster-abc123567.abc87654321.us-west-2.redshift.amazonaws.com"..

    Port

    Enter 5439.

    SSL mode

    Choose None.

    Username

    Enter redshiftadmin.

    Password

    Enter Redshift#123.

    Database name

    Enter test.

    The completed page should look like the following.

    
                     Advanced section
  2. Wait for the status to say Replication instance created successfully..

  3. To test the source and target connections, choose Run Test for the source and target connections.

  4. Choose Next.