Configuring hardware appliance network parameters
After the hardware appliance boots up and you set your admin user password in the hardware console as described in Accessing the hardware appliance console, use the following procedure to configure network parameters so your hardware appliance can connect to Amazon.
To set a network address
-
From the Home page, choose Configure Network and then press
Enter
. The Configure Network page appears. The Configure Network page shows IP and DNS information for each of the 4 network interfaces on the hardware appliance, and includes menu options to configure DHCP or Static addresses for each. -
For the em1 interface, do one of the following:
-
Choose DHCP and press
Enter
to use the IPv4 address assigned by your Dynamic Host Configuration Protocol (DHCP) server to your physical network port.Note this address for later use in the activation step.
-
Choose Static and press
Enter
to configure a static IPv4 address.Enter a valid IP Address, Subnet Mask, Gateway, and DNS server address for the em1 network interface.
When finished, choose Save and then press
Enter
to save the configuration.
Note
You can use this procedure to configure other network interfaces in addition to em1. If you configure other interfaces, they must provide the same always-on connection to the Amazon endpoints listed in the requirements.
Network bonding and Link Aggregation Control Protocol (LACP) are not supported by the hardware appliance or by Storage Gateway.
We do not recommend configuring multiple network interfaces on the same subnet as this can sometimes cause routing issues.
-
To log out of the hardware console
-
Choose Back and press
Enter
to return to the Home page. -
Choose Logout and press
Enter
to return to the Welcome page.
Next step
Activating your Amazon Storage Gateway Hardware Appliance