Register sources with a multicast group in Amazon Transit Gateway
This procedure is only required when you have set the Static sources support attribute to enable.
Use the following procedure to register sources with a multicast group. The source is the network interface that sends multicast traffic.
You need the following information before you add a source:
-
The ID of the multicast domain
-
The IDs of the sources' network interfaces
-
The multicast group IP address
To register sources using the console
-
Open the Amazon VPC console at https://console.amazonaws.cn/vpc/
. -
On the navigation pane, choose Transit Gateway Multicast.
-
Select the multicast domain, and then choose Actions, Add group sources.
-
For Group IP address, enter either the IPv4 CIDR block or IPv6 CIDR block to assign to the multicast domain.
-
Under Choose network interfaces, select the multicast senders' network interfaces.
-
Choose Add sources.
To register sources using the Amazon CLI
Use the register-transit-gateway-multicast-group-sources command.